Recording Still Pictures On A Card While Recording Image Onto A Tape; Check The Recording; Blank Search Function; Recording Still Pictures Onto A Card (Photoshot) - Panasonic Palmcorder MultiCam PV-GS65 Operating Instructions Manual

Recording still pictures on a card
while recording image onto a tape
You can record still pictures while recording
image onto a tape.
≥Set to Tape Recording Mode.
1
Press the [PHOTO SHOT] button fully while
recording image onto a tape.
≥For the number of still pictures to be recorded
on a card, refer to
≥When recording pictures onto a card, the
recording start/stop button is disabled.
≥You can select a picture quality for still pictures
to be recorded. (
-27-
≥In tape recording mode, the size of pictures that
can be recorded is [640].
≥In order to record higher quality still pictures,
you must use the card recording mode.

Check the recording

The last image recorded is played back for 2 to
3 seconds. After checking, the Camcorder will be
set to a recording pause.
≥Set to Tape Recording Mode.
1
Press the joystick during the recording
pause until the icon 1 appears.
2
Move the joystick down to select the
recording check icon [
26
LSQT0860
PHOTO
SHOT
.
-66-
)
].
Record mode

Blank search function

Searches for the last part of the image recorded
(unused part of the tape).
≥Set to Tape Recording/Playback Mode.
1
Set [BASIC] or [ADVANCE] >>
[BLANK SEARCH] >> [YES].
ª
Stopping a blank search midway
through
Move the joystick down.
≥If the cassette tape has no blank part, then the
Camcorder will stop at the end of the tape.
≥The Camcorder stops at a point approx.
1 second before the end of the last image
recorded. When you start recording at that
point, the image can be recorded seamlessly
from the last image.
Recording still pictures onto a card
(Photoshot)
≥Set to Card Recording Mode.
1
Press the [PHOTO SHOT] button.
ª
To record still pictures clearly
≥When zooming in on the subject with a
magnification of 4k to 10k or higher, it is
1
difficult to reduce the slight shaking from holding
the Camcorder by hand. We recommend
decreasing the zoom magnification and
approaching the subject when recording.
≥When recording still pictures, hold the
Camcorder firmly with your hands and keep
your arms stationary at your side so as not to
shake the Camcorder.
≥You can record stable pictures without shaking
by using a tripod and the remote control.
≥For the number of still pictures to be recorded
on a card, refer to
≥The sound cannot be recorded.
≥While data is being recorded on a card, do not
operate the mode dial.
≥When the access lamp is lit, do not insert or
remove a card.
PHOTO
SHOT
.
-66-