Panasonic Palmcorder PV-DV103 Operating Instructions Manual page 48

PC Connection
PHOTOVU LINK Driver (Optional)
An image recorded on the DV Tape can be transferred to your PC (Personal Computer).
System Requirements for PHOTOVU LINK Driver (Optional)
• IBM PC/AT or compatible
® ®
• Intel Pentium Processor
• Microsoft Windows 98/98SE/ME/2000/XP
• RAM: 16 MB or more
• 2 MB minimum available hard disk space
• 256 color monitor (full color recommended)
*Satisfy the conditions recommended by Microsoft for Windows.
Connection
1
Turn off your PC.
2
Connect the Palmcorder to your PC (Windows) using the PC connecting cable
(optional: PC Connection Unit (PV-DRS2A, p. 51)).
• Before connecting the Palmcorder to the PC, make sure the PC
power is off to insure that images are transferred properly.
3
Turn on your PC.
4
Set the Palmcorder POWER to VCR.
Note
• For extended periods of use, it is recommended to use the AC Adaptor as a power
source.
• Refer to PC or Windows manual to identify which COM port is to be used for connection.
48
For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : consumerproducts@panasonic.com
To PC Connector
2
PC Connecting Cable for Windows
(optional: PC Connection Unit (PV-DRS2A, p. 51))
• 3.5 inch 1.44 MB floppy disk drive
(for installation)
• RS-232C serial port (D-Sub 9-pin)
An adaptor (D-Sub 9-pin male to a
D-Sub female) is required for a
D-Sub 25-pin
• Mouse or other pointing device
4
RS-232C Serial port
(D-Sub 9-pin)
(Default is COM1.)