Panasonic Palmcorder PV-DV103 Operating Instructions Manual page 10

Before Using
Remote Controlling Two
Palmcorders
You can control any two Panasonic
Palmcorders with one Remote control
(Optional). In order for the remote to
distinguish between the two units, it is
necessary to set one of the Palmcorders to
VCR 2. On the remote, press VCR 1 or
VCR 2 to control the desired Palmcorder.
3, 4
JOG KEY
2
MENU
1
POWER
Optional
For VCR 2:
Press these
buttons at the
same time.
Note
• When the Palmcorder and remote are
not set to the same mode (VCR1 or
VCR2), "CHECK REMOTE MODE
(REMOTE)" will appear.
10
For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : consumerproducts@panasonic.com
1
Set POWER to VCR or CAMERA.
• The POWER Lamp lights red.
• Be sure POWER is fully turned to
2
3
4
5
For VCR 1:
Press these
buttons at the
same time.
• After replacing the Remote Control
Battery, the remote will default to VCR 1.
VCR or CAMERA position.
Press MENU to display the VCR or
CAMERA mode menu screen.
Rotate JOG KEY to select
FUNCTIONS in the CAMERA or VCR
mode menu screen, then press JOG
KEY to display the OTHER
FUNCTIONS menu screen.
Rotate JOG KEY to select
and then press JOG KEY to select
VCR 2. (Menu OSD: pp. 66, 68).
Leave the other Palmcorder set to
VCR1.
Set the Remote Control (Optional) to
VCR 1 or VCR 2 to correspond with
the Palmcorder you wish to control.
(See above left.)
OTHER
REMOTE ,