Table of Contents
Advertisement
Installation Manual
H3C S3610 Series Ethernet Switches
Chapter 3 Installing the Switch
Caution:
When you ask your sales agent to maintain the switch, you must ensure that the H3C
dismantlement-preventive seal on a mounting screw of the switch chassis is intact. If
you want to open the chassis, you should contact the agent for permission. Otherwise,
you will bear any consequence resulted from your actions without permission.
3.1 Installing a Switch
3.1.1 Mounting a Switch to a Cabinet
You can install a switch into a 19-inch standard cabinet in one of the following three
ways:
Use front mounting ears
Use front mounting ears and a tray
Use front mounting ears and guide rails
Note:
The front mounting ears are provided in the standard package, while trays and
guide rails are optional parts that you need to order as needed.
When the switch is more than 300 mm (11.81 in.) in width, the front mounting ears
are not used for bearing but for fixing only.
When installing devices, ensure a clearance of 1U (44.45 mm, namely, 1.75 inches)
between devices for heat dissipation.
The guide rails provided by H3C are suitable for H3C 1000 mm (39.37 in.) standard
cabinets only. If the depth of your cabinet does not fit, use other supports to replace
the guide rails.
I. Introduction to mounting ear
Figure 3-1 shows the appearance of a front mounting ear.
3-1
Chapter 3 Installing the Switch
Advertisement
Table of Contents
