Safety Instructions - Zanussi ZDPB274B User Manual

Wipe away lint or packaging debris that has accumulated
•
around the appliance.
Do not run the appliance without a filter. Clean the lint filter
•
before or after each use.
Do not dry unwashed items in the tumble dryer.
•
Items that have been soiled with substances such as cooking
•
oil, acetone, alcohol, petrol, kerosene, spot removers,
turpentine, waxes and wax removers should be washed in hot
water with an extra amount of detergent before being dried in
the tumble dryer.
Items such as foam rubber (latex foam), shower caps,
•
waterproof textiles, rubber backed articles and clothes or
pillows fitted with foam rubber pads should not be dried in the
tumble dryer.
Fabric softeners, or similar products, should only be used as
•
specified by the product manufacturer's instructions.
Remove all objects from items that could be a source of fire
•
ignition such as lighters or matches.
WARNING: Never stop a tumble dryer before the end of the
•
drying cycle unless all items are quickly removed and spread
out so that the heat is dissipated.
Before any maintenance operation, deactivate the appliance
•
and disconnect the mains plug from the socket.

SAFETY INSTRUCTIONS

INSTALLATION
• Remove all the packaging.
• Do not install or use a damaged appliance.
• Follow the installation instructions supplied with
the appliance.
• Always take care when moving the appliance as
it is heavy. Always use safety gloves and
enclosed footwear.
• Do not install or use the appliance where the
temperature can be lower than 5°C or higher
than 35°C.
• The floor area on which the appliance is to be
installed must be flat, stable, heat resistant and
clean.
• Make sure that there is air circulation between
the appliance and the floor.
• Always keep the appliance vertical when it is
being moved.
4
• The rear surface of the appliance must be put
against a wall.
• When the appliance is in its permanent position,
check if it is levelled correctly with the aid of a
spirit level. If it is not, adjust the feet accordingly.
ELECTRICAL CONNECTION
WARNING! Risk of fire and electric
shock.
• WARNING: This appliance is designed to be
installed / connected to a grounding connection
in the building.
• Make sure that the parameters on the rating
plate are compatible with the electrical ratings
of the mains power supply.