Zanussi ZDPB274B User Manual page 17

Error code
EH0
If the display shows other error codes, deactivate and activate the appliance. If the problem continues,
contact the Authorised Service Centre.
In case of different problem with the tumble dryer check the table below for possible solutions.
TROUBLESHOOTING
You cannot activate the appliance.
The programme does not start.
The appliance door does not close.
The appliance stops during operation.
The cycle time is too long or unsatisfactory dry-
1)
ing result.
Possible cause
The mains supply is unstable.
Problem
When the appliance is showing EH0,
please wait until main supply is stable
than press start. If the appliance
pause the cycle without any indication
then press the cycle start. If the warn-
ing will occur check the power cord /
socket integrity or main supply.
Possible solution
Make sure that the mains plug is connected to
the mains socket.
Check fuse in fuse box (domestic installation).
Press ‫( התחלה‬Start/Pause).
Make sure that the appliance door is closed.
Make sure that the installation of the filter is cor-
rect.
Make sure that the laundry does not catch be-
tween the appliance door and the rubber seal.
Make sure that the water container is empty.
Press ‫( התחלה‬Start/Pause) to start the pro-
gramme again.
Load is too small, increase the load or use the
‫זמן‬ ‫לפי‬ ‫ייבוש‬
(Time Drying) programme.
Make sure that the weight of the laundry is appli-
cable to the duration of the programme.
Make sure that the filter is clean.
The laundry is too wet. Spin the laundry in the
washing machine again.
Ensure that the room temperature is higher than
+5°C and lower than +35°C. Optimal room tem-
perature is 18°C to 25°C.
‫זמן‬ ‫לפי‬ ‫ייבוש‬
Set the
(Extra Dry) programme.
Remedy
(Time Drying) or the ‫נוסף‬
2)
17