Fluke Smartview Ir Software - Fluke RSE30 User Manual

RSE30/RSE60/RSE30H/RSE60H
Users Manual
3. Open the IPConfig software and search for the Camera's IP address. The Camera's IP address is
192.168.1.100.
4. Start the Fluke SmartView IR software and connect to the Camera using the IP address
192.168.1.100.
5. For the next steps, please see the Fluke SmartView IR software's Users Manual.
The default IP address of the Product is 192.168.1.100, and when you use the Reset
button to reset the Product, the default IP address is restored. Do not set servers or
other PCs and network devices to this IP address. To change the IP address of the
Product, see the instruction manual for the IPConfig software.

Fluke SmartView IR Software

The Fluke SmartView IR software can be used with the Camera and contains functions for analyzing
images, organizing data and information and generating professional reports.
Use the SmartView IR software to:
stream radiometric videos
•
capture fully-radiometric videos or imagers
•
analyze images
•
plot data trends
•
export data
•
customize reports
•
To download and install the SmartView IR Software.
1. On the PC, go to: www.fluke.com/smartviewIR.
2. Download the SmartView IR software to the PC according to the instructions on the Product page.
3. On the PC, follow the instructions to install SmartView IR software. (Administrator privileges are
required for the installation.)
For details on remote viewing and control of the Product connected to the SmartView IR software, see
the instructions for the software.
6
Note