Battery Installation - 3Com PalmPilot Professional Handbook

Battery Installation

To use the PalmPilot, you must install two (2) AAA alkaline
batteries. The batteries fit behind the battery door on the back of
your PalmPilot.
To install the batteries in your PalmPilot,
1. Remove the battery door from the rear of PalmPilot.
Push on the thumb recess on the battery door, as
shown in the following diagram:
2. While pushing the thumb recess, slide the battery door out
and away from PalmPilot.
3. Install the two (2) AAA alkaline batteries into the battery
compartment. These batteries are supplied with your
PalmPilot.
A diagram in the interior of the battery compartment shows
the orientation of the + and - ends of the batteries.
When correctly installed, the batteries will be secured by clips
in the battery compartment.
4. Replace the battery door. When correctly installed the battery
door will "click" into position, and be flush with the back of the
PalmPilot.
page
8
Push on thumb recess
PalmPilot Handbook