H3C S5130S-EI Series Hardware Information page 67

•
2.5G/1000/100BASE-T autosensing Ethernet port LEDs
•
5G/2.5G/1000BASE-T autosensing Ethernet port LEDs
•
10/5/2.5/1GBASE-T autosensing Ethernet port LEDs
Table4-20 describes the Ethernet port LEDs on a non-PoE switch.
Table4-19 Ethernet port LED description for PoE switch models
Mode LED Ethernet port LED
status status
Steady green
Steady green
(Link/Active Flashing green
mode)
Off
Steady green
Flashing
Flashing green (1 Hz)
green (PoE
mode)
Off
Flashing
yellow (IRF Steady green
mode)
Table4-20 Ethernet port LED description for non-PoE switch models
LED status
Steady green
Flashing green
Off
Description
A link is present on the port.
The port is sending or receiving data.
No link is present on the port.
PoE power supply is normal.
•
The maximum PoE power provided by the port fails to
meet the power requirement of the PD.
•
PoE power supply overcurrent, overvoltage, or
short-circuit occurs.
•
The remaining power of the switch fails to meet the
power supply requirement of the port.
The port is not connected to a PD or PoE is not enabled on
the port.
The Ethernet port LEDs on the switch work in conjunction to
indicate the IRF member ID of the switch. For example, if the
LED for port 5 is steady green and the other port LEDs are
off, the IRF member ID of the switch is 5.
Description
A link is present on the port.
The port is sending or receiving data.
No link is present on the port.
4-62