Table of Contents
Advertisement
3 R Picture
3R(= Resolution and Response Recovery technology) maximises
sense of resolution and sharpens image edges to make playback
picture look better focused.
ACTIVATE 3R PICTURE
1
Press 3R PICTU RE . The button will light.
● To turn off 3R Picture, press
that the light goes off.
● Normally it is recommendable to keep 3R Picture ON
(with the button lit).
● Depending on the type of tape used, picture quality
may be better with 3R Picture set to off.
● If you use this recorder as the player for editing, be
sure to turn off 3R Picture before starting.
● The setting will remain effective even though you
turn on/off the recorder.
N TSC Pla yba ck
Your video recorder is equipped with NTSC circuitry that can
play back NTSC tapes.
LO AD A CASSETTE
Insert a cassette recorded in NTSC.
1
START PLAYBACK
2
Press PLAY .
● "NTSC" appears on the screen for about 5 seconds.
● Some TVs shrink the picture vertically and place
black bars at the top and bottom of the screen. This is
not a malfunction on the part of either the video
recorder or the TV.
● The picture may roll up and down. This can be
corrected using the V-HOLD control found on some
TVs. (This cannot be corrected if the TV does not
have a V-HOLD control.)
● The counter and tape remaining time readings will be
incorrect.
● During search, still, or frame-by-frame playback, the
picture will be distorted, and there may be a loss of
colour.
● Depending on the type of TV, the top and bottom
portions of superimposed displays may be cut off
during NTSC playback.
Downloaded from:
https://www.usersmanualguide.com/
3R PICTU RE again so
Repea t Pla yba ck
Your video recorder can automatically play back the whole tape
20 times repeatedly.
ST ART PLAYBACK
1
Press PLAY .
ACTIVATE REPEAT
PLAYBACK
2
Press PLAY and hold for over 5 seconds, then release.
● The Play indicator ( $ ) on the display panel blinks
slowly.
● The tape plays 20 times automatically, and then
stops.
STO P PLAYBACK
3
Press STO P at any time to stop playback.
N O TE:
Pressing PLAY , REW , FF or PAU SE also stops Repeat Playback.
Informa tion O n Colour
System
You can also record SECAM signals, or play back a MESECAM
tape on this recorder. When a MESECAM tape is played back,
"MESECAM" appears on the screen for about 5 seconds.
MESECAM is the designation for tapes with SECAM signals that
have been recorded on a MESECAM-compatible PAL video
recorder.
15
EN
Advertisement
Table of Contents
