Yamaha SX150C Service Manual page 253

BRKT
RESERVOIR AND POWER TRIM AND TILT MOTOR
7240
7250
MEASURING THE HYDRAULIC
PRESSURE
Inspect:
• Hydraulic pressure
Out of specification → Repair.
Hydraulic pressure
(with the power trim and tilt ram
assemblies fully extended)
9.8 - 11.8 MPa
(100 - 120 kg/cm
(with the power trim and tilt ram
assemblies fully compressed)
5.9 - 8.8 MPa (60 - 90 kg/cm
NOTE:
Before measuring the hydraulic pressure,
bleed the power trim and tilt unit.
Measuring steps
(1) Fully tilt up the power trim and tilt ram
assemblies.
(2) Remove the circlip 1.
(3) Remove the manual valve 2 and
install the up-relief valve attachment
and hydraulic pressure gauge and
tighten them to the specified torque.
Up-relief valve attachment ...... 3
90890-06773
Hydraulic pressure gauge ........ 4
90890-06776
Hydraulic pressure gauge
9 Nm (0.9 m • kgf, 6.5 ft • lb)
Up-relief valve attachment
4 Nm (0.4 m • kgf, 2.9 ft • lb)
NOTE:
Remove the manual valve and then quickly
attach the special tools before any fluid
comes out.
7-26
E
2
)
2
)