OWI AMPIC5 Installation Instructions Manual page 4

AMPIC5 / AMPIC6 carton includes the following items:
1. One (1) each AMPIC5 or AMPIC6
2. One (1) each UL Listed Power Supply
( IC5/IC6, Tile Bridge, Backcan and Volume Controls are Optional – Sold Separately)
Introduction:
The AMPIC5/AMPIC6 is designed to provide an OWI 5.25" (IC5) or 6.5" (IC6) speaker that is self powered
allowing line input audio that is either balanced or unbalanced to provide the input signal. The power amplifier
provides up to 25 watts of power. It has enough power to allow up to a total of four non-amplified speakers to
be powered by one power amplifier installed on one of the four non-amplified speakers. This would then allow
each speaker to have approximately 5 watts of power. Five watts would be enough power for background
music, voice paging or many voice applications. The AMPIC5/AMPIC6 can also be daisy chained up to a
maximum of 20 connected amplified speakers.
Specifications:
Model Number
Frequency Response
THD
S/N
Input Configuration
Minimum Common Mode Rejection
Maximum Power Output
At load impedance
Minimum Power Supply Voltage
Maximum Supply Voltage
Maximum current protected
Short Circuit protected
One wire to ground protected
Minimum Load Impedance
Input Load Impedance
Plastic
Maximum number of Amplifiers on one line
Available Backcan (Sold Separately)
Available Tile Bridge (Sold Separately)
Warranty
Installation Instructions
Model AMPIC5 / AMPIC6
(UL Listed)
AMPIC5 / AMPIC6
50 Hz to 15 kHz. HF is optimized to enhance frequency
response of the speaker.
<.1%
>90dB
Differential (noise reducing)
40dB
25 Watts
4 Ohms (2 speakers in parallel or 4 speakers in series parallel)
8 Volts
14 Volts
Yes
Yes
Yes
3.2 Ohms
10K Ohms
Fire rated V-0
20
UL Listed and Plenum rated
Support Truss
1 year
Page 4 of 16
Filename:AMPIC5_6 MANUAL
07/18/08