Table of Contents
Advertisement
AMP4IC6 carton includes the following items:
1. One (1) each AMP4IC6
2. One (1) each UL Listed Power Supply
Introduction:
The AMP4IC6 is designed to provide a 6.5 inch speaker that is self powered allowing line input audio that is
either balanced or unbalanced to provide the input signal. The power amplifier provides up to 25 watts of
power. It has enough power to allow up to four total speakers to be powered by one powered speaker. The
additional three can be non-powered. This would then allow each speaker to have approximately 5 watts of
power. Five watts would be enough power for background music, voice paging or many voice applications.
Specifications:
Model
Frequency Response
THD
S/N
Input Configuration
Minimum Common Mode Rejection
Maximum Power Output
At load impedance
Minimum Power Supply Voltage
Maximum Supply Voltage
Maximum current protected
Short Circuit protected
One wire to ground protected
Minimum Load Impedance
Input Load Impedance
Maximum number of Amplifiers on
one line
Power Supply
Inputs
Outputs
Controls
Outputs
Heat sink
High Voltage
Protection
Plastic
Available Backcan (Sold Separately)
Warranty
Installation Instructions
Model AMP4IC6
(UL Listed)
AMP4IC6
50 Hz to 15kHz. HF is optimized to enhance frequency response of the
speaker.
<.1%
>90dB
Differential (noise reducing)
40dB
25watts
4 Ohms (2 speakers in parallel or 4 speakers in series parallel)
8 Volts
14 Volts
Yes
Yes
Yes
3.2 Ohm
10K Ohm
4
12 Volts AC 12- 14V AC
4 Balanced Line
1 Balanced Line
4 Input level Controls
1 Line out Level Control
1 Amplifier Gain Control
4 Output Jacks allowing automatic correct
wiring for series parallel connection by simply plugging each speaker
into its jack.
An oversize heat-sink is provided
The highest voltage on the PCB is 12 volts
The amplifier is protected against short and
overheating
Fire rated V-0
UL Listed and Plenum rated
1 year
Page 4 of 14
Filename:AMP4IC6 MANUAL
12/12/06
Advertisement
Table of Contents
