MQ Power WHISPERWATT DCA150SSJU4F2 Operation Manual page 52

FUEL WATER SEPARATOR SEDIMENT BOWL
1. Remove the sediment bowl from the fuel water
separator cartridge as shown in Figure 66.
FUEL FILTER
WATER SEPARATOR
CARTRIDGE
BOWL
Figure 66. Sediment Bowl
2. Let the residue or foreign substances inside the
sediment bowl flow into a suitable container.
3. Wipe the inside of the sediment bowl with a clean cloth
to remove any foreign matter or debris that may have
accumulated.
4. Reinstall the sediment bowl back onto the fuel water
separator cartridge.
5. Tighten securely. DO NOT over-tighten.
PAGE 52 — DCA150SSJU4F2/F3 60 HZ GENERATOR • OPERATION MANUAL — REV. #0 (02/16/22)
FUEL WATER SEPARATOR REPLACEMENT
1. Use a filter wrench to remove the fuel water separator
SEDIMENT
2. Wipe the inside of the fuel water separator cartridge
3. Install the new fuel water separator cartridge first by
4. Tighten the fuel water cartridge securely. DO NOT
Removing Water from the Fuel Tank
After prolonged use, water and other impurities accumulate
in the bottom of the tank. Occasionally inspect the fuel tank
for water contamination and drain the contents if required.
During cold weather, the more empty volume inside the
tank, the easier it is for water to condense. This can be
reduced by keeping the tank full with diesel fuel.
MAINTENANCE
cartridge (Figure 67) from the cartridge body head.
FUEL WATER
SEPARATOR
CARTRIDGE
Figure 67. Fuel Water Separator
body (head) with a clean cloth to remove any foreign
matter or debris that may have accumulated.
hand until it makes contact with the cartridge body
(head) surface.
over-tighten.
CARTRIDGE BODY
(HEAD)
RETAINING
RING