Advertisement
The grill tray should be
positioned between the two
wires of a shelf position and
orientated as shown.
Fitting the side racks and catalytic panels
1. Remove all shelves and trays.
2. For easier access to the fixing screws, you may remove the oven door first. See 'Removing the oven door.'
3. Using a small coin or a flat-head screwdriver, loosen and remove the front and back fixing screws, as shown.
4. Remove the side rack.
5. Fit the catalytic panel. When fitting the side catalytic panels, make sure that:
◦ the arrows are pointing upwards
◦ the panel with the hole is on the right oven wall.
6. Refit the side racks.
◦ make sure that they are the right way up, as in the illustrations, and that you tighten the fixing screws.
7. If not already fitted, fit the telescopic sliding shelf supports.
Fitting and removing the sliding shelf supports
When fitting the sliding shelf supports, make sure that you fit:
https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Induction/OR90SDBSIX1/User_Guide_OR90SDBSIX1/1...
Fig. 29 Oven shelves and grill tray
Updated: Sat, 09 Jul 2022 18:20:57 GMT
Powered by
5
Advertisement
