Operating Modes; How To Use The Back Light; Section 2 The Calendar Clock, Chronometer And Thermometer; How To Set The Calendar Clock - Oregon Scientific AT108A User Manual

OPERATING MODES

Refer to Fig 1 to change from one mode to the other.
Note:
Mode display varies for different models, please refer to the previous
function list for detailed.

HOW TO USE THE BACK LIGHT

Press LIGHT to turn on the back light for five seconds.
Note:
a) When the backlight is ON, any key press will keep it ON for an
additional five seconds.
b) The backlight will not switch on when the battery level is too low.
This indicates a need to change the watch battery.
SECTION 2 THE CALENDAR CLOCK,
CHRONOMETER AND
THERMOMETER
This section applies to OUTBREAKER PLUS and
OUTBREAKER PRO
Refer to diagram A to install the nylon wrist belt to the watch.
There are four display modes when the CLOCK operating mode is
adopted.
Refer to fig 2 to change among the displays.
To display the daily alarm in any of these display modes, press
FUNCTION (fig 2). Then press SELECT to turn on or off the alarm
(fig 4a)
When the daily alarm is activated, it will sound off at the designated
time. Press any control button to mute the alarm.
For OUTBREAKER SMART, OUTBREAKER PLUS and
OUTBREAKER PRO
Refer to diagram B to install the rubber wrist belt to the watch.

HOW TO SET THE CALENDAR CLOCK

Refer to fig 3 to set the calendar clock.
Note:
The calendar clock may also set through the PC software. To connect
the watch to the PC software please refer to Section 7.

HOW TO SET THE ALARM CLOCK

There are 4 alarms – 1 daily alarm & 3 event alarms equipped in the
watch.
A) SET THE DAILY ALARM CLOCK ON THE WATCH
Refer to fig 4b to set the daily alarm clock.
Note:
a) The alarm will be automatically turned on during the setting
procedure.
b) The event alarm can only be set by the PC software. To connect
the watch to the PC sofware please refer to Section 7.
5