Before You Begin; Recommended Tools; Turning Off Your Computer; Safety Instructions - Dell Inspiron One 2305 Service Manual

Back to Contents Page
Before You Begin
Dell™ Inspiron™ One 2305/2310 Service Manual
Recommended Tools
Turning Off Your Computer
Safety Instructions
This manual provides procedures for removing and installing the components in your computer. Unless otherwise noted, each procedure assumes that the
following conditions exist:
You have performed the steps in
l
You have read the safety information that shipped with your computer.
l
A component can be replaced or—if purchased separately—installed by performing the removal procedure in reverse order.
l
Recommended Tools
The procedures in this document may require the following tools:
Small Phillips screwdriver
l
Hex nut driver
l
Flash BIOS executable update program available at support.dell.com
l
Turning Off Your Computer
CAUTION:
1. Save and close all open files and exit all open programs.
2. To shut down the operating system, click Start
3. Ensure that the computer is turned off. If your computer did not automatically turn off when you shut down the operating system, press and hold the
power button until the computer turns off.
Safety Instructions
Use the following safety guidelines to help protect your computer from potential damage and to help to ensure your own personal safety.
WARNING:
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
WARNING:
completed, the enclosure must be replaced and all fasteners installed before connecting to the power source.
CAUTION:
See the safety instructions for complete information about safety precautions, working inside your computer, and protecting against electrostatic
discharge.
CAUTION:
surface (such as a connector on your computer).
CAUTION:
tabs; if you are disconnecting this type of cable, press in on the locking tabs before you disconnect the cable. As you pull connectors apart, keep
them evenly aligned to avoid bending any connector pins. Also, before you connect a cable, ensure that both connectors are correctly oriented
and aligned.
CAUTION:
1. Ensure that the work surface is flat and clean to prevent the computer display from being scratched.
2. Turn off your computer (see
Great user manuals database on

Turning Off Your Computer

To avoid losing data, save and close all open files and exit all open programs before you turn off your computer.
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
Disconnect all power sources before opening the enclosure to replace, remove, or install accessories. After the installation is
Only a certified service technician is authorized to remove the computer cover and access any of the components inside the computer.
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
When you disconnect a cable, pull on its connector or on its pull-tab, not on the cable itself. Some cables have connectors with locking
To avoid damaging the computer, perform the following steps before you begin working inside the computer.
Turning Off Your Computer) and all attached devices.
UserManuals.info
and Safety Instructions.
and then click Shut Down.