Set 5: Start Feed; Set 6: Side Margin - MUTOH ValueJet VJ-1948WX Operation Manual

Near End menu
Print Stop :
Enter

Set 5: Start Feed

Set 5: Start Feed
Note
With take-up system: if you want to set "Start Feed" to below 0, set "Page Gap" to "Narrow".
If not, the Start Feed setting is not reflected properly.
"When the "Output Mode" is set to "Take Up"" P. 71

Set 6: Side Margin

Set 6: Side Margin
Note
When the "Spitting menu" is set to "On Media", the maximum printable media width becomes 16 mm shorter.
Therefore, the side margins become the value that you have set in Side Margin menu +8 mm.
"Set 19: Spitting" P. 75
Sets whether or not to display "Roll Near End: *m" (* is replaced with a number between
On
1 and 10) before the length of the roll media that is counted inside the printer becomes 0.
Setting values
Near End :
Near End :
You can change the margin setting between images.
• Value over 0: The margin setting between images will be wider than when setting "0".
• Value equal to 0: The default margin setting between images will be applied.
• Value below 0: The margin setting between images will be smaller than when setting
"0".
Setting values
Start Feed :
Set up the right and left margins (side margins) while printing.
Use the [+] / [ - ] key to enter the value, and press the [Enter] key.
Setting values
Side Margin :
"Near end" is not displayed.
Off
This is the initially set value.
"Near end" is displayed when the remaining
Remain * m
count for the roll media becomes the length
you selected.
-10 mm to <150 mm> to 500.0 mm
150 mm
<> indicates the initial value.
<5 mm> to 25 mm
5 mm
<> indicates the initial value.

Set 5: Start Feed

69