Husqvarna CT 36A Operator's Manual page 17

WARNING:
directly after the engine stops. Make sure
the engine is cool before you drain the
engine oil. If you spill engine oil on your skin,
clean with soap and water.
1. Loosen the oil drain hose from the holder.
2. Put a container below the oil drain hose.
3. Remove the plug from the end of the oil drain hose.
4. Tilt the product and let the oil run out into the
container.
5. Install the plug in the oil drain hose.
6. Install the oil drain hose in the holder.
7. Fill with new engine oil. Refer to
page 25 or the engine manual for the correct type
of oil.
8. Do a check of the engine oil level.
Air filter
WARNING:
protection when you clean or replace the
air filter. Discard used air filters correctly.
Inhalation of the dust in the air filter may be
dangerous to your health.
CAUTION:
air filter, or the dust will go into the engine
and cause engine damage.
To clean or replace the air filter
WARNING:
with compressed air. This causes damage to
the air filter and the risk increases that you
breathe the dangerous dust.
1. Turn the knob on the air filter cover and remove the
air filter cover.
1452 - 003 - 30.01.2023
Engine oil is very hot
Technical data on
Use approved respiratory
Always replace a damaged
Do not clean the air filter
2. Remove the paper filter element and the foam filter
element (A).
3. Clean the air filter housing with a brush.
4. Examine the air filter elements for damage.
5. Tap the paper filter element against a hard surface
or use a vacuum cleaner to remove the particles.
CAUTION:
the vacuum cleaner touch the surface of
the paper filter element. Keep a small
distance. The sensitive surface of the
paper filter element becomes damaged
if objects touch it.
6. Clean the foam filter element with a solution of soap
and water.
7. Flush the foam filter element in clean water.
8. Compress the foam filter element to remove the
water and let the foam filter element dry fully.
9. Lubricate the foam filter element with engine oil.
10. Push a clean cloth against the foam filter element to
remove unwanted oil.
11. Install the air filter in the opposite sequence.
To replace the belt
WARNING:
without the belt cover installed.
1. Stop the engine and disconnect the spark plug
cable.
2. Remove the screws and washers that hold the belt
cover. Remove the belt cover.
A
Do not let the nozzle of
Do not operate the product
17