Husqvarna CT 36A Operator's Manual page 11

To install the throttle cable
1. Move the throttle control to the idle speed position.
2. Put the throttle cable through the clamp on the recoil
cover of the engine.
3. Put the bend of the throttle cable in the hole in the
throttle plate (A).
A
Note:
The air filter assembly can be removed to
get easier access.
1452 - 003 - 30.01.2023
B
4. Hold the throttle control in the idle speed position
while you put the bracket (B) on top of the throttle
cable.
5. Install the air filter assembly if it was removed.
To connect the wires from the handle to
the engine
1. Connect the wires (A) from the handle to the yellow
wires (B) from the engine.
2. Connect the green ground wire from the handle to
the green wire from the engine.
a) If the product has a green wire installed on the
engine, discard the green wire supplied with the
handle.
b) If the product does not have a green wire
installed on the engine, remove the nut (C),
install the ground wire and tighten the nut to 24
Nm/18 lb-ft.
To do a function check after assembly
1. Start the engine. Refer to
page 12 .
2. Do a check of the idle speed and the clutch. Refer to
Technical data on page 25 for the correct value.
A
B
C
To start the product on
11