Onkyo HT-R495 Service Manual page 48

1
Overall
MMB/MMT only
D
C
A405
BADIS-2672
BAETC-2679
A204
B
A208
A209
A202
A203
A
A211A
A211
1
2
A408
A405
A401
A206
A207
A210
BAETC-2696
A205
＊This module transmitter does not have RF shielding,
therefore it will be equipped only the tested Audio system
mentioning this document.
Additional test will be required if it will be equipped to the
other devices.
A201
2
3
P7001
: Bluetooth Module
3
4 5
＊WiFi & Bluetooth Module has already been certificated by FCC and IC.
Information to the user.
Indicate "Contains FCC ID: UOW-AB152X", "Contains IC: 6777A-AB152X" and following
information to the host device installed.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
Describe the following sentence to a user's manual of the host device.
[For FCC]
FCC CAUTION
Changes or modifications not expressly approved by the party responsible for compliance
could void the userʼs authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
̶ Reorient or relocate the receiving antenna.
̶ Increase the separation between the equipment and receiver.
̶ Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
̶ Consult the dealer or an experienced radio/TV technician for help.
This transmitter must not be co-located or operated in conjunction with any other antenna
or transmitter.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment and meets the FCC radio frequency (RF) Exposure Guidelines in Supplement C
to OET65. This equipment has very low levels of RF energy that it deemed to comply without
maximum permissive exposure evaluation (MPE). But it is desirable that it should be installed
and operated keeping the radiator at least 20cm or more away from personʼs body
(excluding extremities: hands, wrists, feet and ankles).
[For IC]
CAN ICES-3 B/NMB-3 B
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is
A002
subject to the following two conditions: (1) this device may not cause interference, and (2)
x4
this device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
A003
exempts dlicence.
L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire
x4
de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement.
This equipment complies with IC radiation exposure limits set forth for an uncontrolled
environment and meets RSS-102 of the IC radio frequency (RF) Exposure rules. This
equipment has very low levels of RF energy that it deemed to comply without maximum
permissive exposure evaluation (MPE). But it is desirable that it should be installed and
operated keeping the radiator at least 20cm or more away from personʼs body (excluding
extremities:hands, wrists, feet and ankles).
Cet équipement est conforme aux limites dʼexposition aux rayonnements énoncées pour un
environnement non contrôlé et respecte les règles dʼexposition aux fréquences
radioélectriques (RF) CNR-102 de lʼIC. Cet équipement émet une énergie RF très faible qui
est considérée conforme sans évaluation de lʼexposition maximale autorisée. Cependant, cet
équipement doit être installé et utilisé en gardant une distance de 20 cm ou plus entre le
dispositif rayonnant et le corps (à lʼexception des extrémités : mains, poignets, pieds et
chevilles).
4 5
6
Exploded Views
D
C
B
A
HT-R495
6