Return To Idle Screen; Register A Sip Account; Register Account Via Web User Interface - Grandstream Networks DP750 User Manual

2. Use arrow keys to reach Settings
3. Navigate to Display, and then press "Select" (left softkey).
4. Set desired time in seconds for Backlight timeout and for Menu timeout. Available value: 15 seconds, 30 seconds, 60
seconds or disabled. (Default is 30 seconds)
5. Press Save (left softkey) to save and apply the new settings.

Return to Idle Screen

Press the Power Key
If you do not press any key in a period of time, the LCD screen will automatically exit the menu and return to the idle screen as
well.
When you are navigating on the handset's menu, and you receive an incoming call, the LCD screen will automatically exit the
menu and you can either accept or reject the call. When the call is terminated, the LCD screen will return back to the idle
screen.

Register a SIP Account

DP750 supports up to 10 SIP accounts, 5 handsets. Each handset can be configured up to 10 accounts. Please be aware that
line settings will be affected by DID settings (hunting group settings) in "DECT �� SIP Account Settings". For more details
about "Hunting Group", please refer to

Register Account via Web User Interface

1. Access your DP750 base station web UI by entering its IP address in your favorite browser.
2. Enter your admin's username and password (Starting HW version 1.7A the default admin username is 'admin' while the
admin password is the random password that can be found on the sticker at the back of the unit. For lower hardware
versions; the default username and password are: admin/admin).
3. Press Login to access your settings.
4. Go to Profiles tab and select a profile to use.
Note: DP750 supports up to 4 profiles. A profile is a set of settings including general settings, network settings, SIP
setting, audio setting, call settings and ring tones, etc.
A profile can be used with different SIP accounts.
5. In General Settings, set the following:
Profile Active to Yes.
SIP Server field with your SIP server IP address or FQDN.
Failover SIP Server with your failover SIP server IP address or FQDN. Leave empty if not available.
Prefer Primary SIP Server to No or Yes depending on your configuration. Set to No if no failover SIP server is
defined. If "Yes", account will register to primary SIP server when failover registration expires.
Outbound Proxy with your outbound proxy IP address or FQDN. Leave empty if not available.
Voice Mail Access Number Allows users to access voice messages. This value is usually the VM portal access
number. For example: configuring the access code to "*97,,password" will automatically dial the Voice Mail box and
enter the password.
6. Press Save and Apply to save your configuration.
7. Go to DECT �� SIP Account Settings
.
to quickly exit the menu and return back to the main idle screen.
"Administration Guide".