Nectre Fireplaces Form 2 Series Operating Instructions Manual

Premium portrait wood heater

Advertisement

Quick Links

OPERATING INSTRUCTIONS
PREMIUM PORTRAIT WOOD HEATER

Advertisement

Table of Contents
loading

Summary of Contents for Nectre Fireplaces Form 2 Series

  • Page 1 OPERATING INSTRUCTIONS PREMIUM PORTRAIT WOOD HEATER...
  • Page 2 Glen Dimplex Australia proudly supports the activities of Landcare Australia through its membership of the AHHA. NECTRE FORM 2 (NF2-22) VERSION 1.0...
  • Page 3: Table Of Contents

    TABLE OF CONTENTS USER INSTRUCTIONS MAINTENANCE AND SERVICING Introduction ......... . Replacement of Vermiculite .
  • Page 4: User Instructions

    USER INSTRUCTIONS INTRODUCTION 1.1. AIR CONTROLS Before use of this appliance please read these instructions The Nectre Form 2 features a single air control system. fully. This single control modulates the amount of oxygen that enters the firebox at two points - at the top of the door WARNING: ANY MODIFICATION OF THE APPLIANCE glass, as well as directly at the base of the fire controlling THAT HAS NOT BEEN APPROVED IN WRITING BY...
  • Page 5: Wood Storage Compartment

    LIGHTING THE FIRE 1.3. WOOD STORAGE COMPARTMENT Warning: the Nectre Form 2 features a storage area Place firelighters and/or paper and dry kindling for a small amount of firewood. Do not overload this wood in the base of the firebox. compartment - ensure that there is at least a 5mm gap to Fully open the air control located on the bottom left the ceiling of the unit, and no combustible fuel forward of...
  • Page 6: Low Heat Output

    BURNING TIPS 5.2. LOW HEAT OUTPUT The heat output of the appliance can be reduced by 6.1. FUEL QUALITY closing the air control (sliding all the way counter- Use wood with a moisture content of less than 20%. Logs clockwise) which will restrict the oxygen supplied to the should not feel moist/damp, or have moss/fungal growths.
  • Page 7: Ash Removal

    CLEANING THE FLUE For advice on the correction of persistent flue problems consult your supplier/installer for more detail. Check inside of flue prior to each season for any build-up of creosote (wood tar). To do this: ASH REMOVAL First remove the baffle (refer to “2. Replacement of Depending on the type of wood burnt and frequency, the Baffle”...
  • Page 8: Troubleshooting Tips

    TROUBLESHOOTING TIPS 11.1. GLASS IN DOOR BLACKENING This can have several possible causes: ● Burning unseasoned wood — if the wood is too wet, it will cause the glass to blacken. ● Appliance operated at low temperature — after an overnight burn where the air slide control has been fully closed, the glass may have blackened.
  • Page 9: Maintenance And Servicing

    MAINTENANCE AND SERVICING REPLACEMENT OF VERMICULITE REPLACEMENT OF BAFFLE Vermiculite is a naturally occurring aluminium-magnesium The 25mm thick vermiculite baffle helps to retain heat in silicate material that is non-toxic and environmentally the firebox by lengthening the path of the flames so that friendly.
  • Page 10: Fitting A New Door Seal

    FITTING A NEW DOOR SEAL FITTING NEW DOOR GLASS Remove the door from the heater and lay it horizontally on To replace the door glass, remove the door from the heater a work-bench. and lay it horizontally on a work-bench. Remove any old seal from the door.
  • Page 11: Adjusting Door Latch

    ADJUSTING DOOR LATCH Over time, the door seal can become compressed, resulting in a less than adequate seal between the door and the front face of the firebox. For example, if the wood burns unusually fast even with the air control set to low, it may mean that there is an air leak around the door.
  • Page 12: Replacement Spare Parts List

    REPLACEMENT SPARE PARTS LIST PART NO. PART DETAIL N900-373 Vermiculite set 2 @ 280 x 189 x 25mm with one angled edge 2 @ 280 x 110 x 25mm with two angled edges 1 @ 280 x 217 x 25mm with two angled edges N111-082 Brick retainer Stainless steel...
  • Page 13: Warranty

    WARRANTY Glen Dimplex Australia Pty. Ltd. warrants this stove to be able to operate under normal use and service and within 10 years from the date of the original purchase on the terms herein shall repair or replace without cost to the original customer any part thereof which shall be returned to our factory, transportation charges prepaid and which our inspection shows would prevent operation.
  • Page 16 Glen Dimplex Australia Pty Ltd 8 Lakeview Drive, Scoresby Victoria 3179 Australia T: 1300 556 816 | F: 1800 058 900 General and Sales Enquiries: flame@glendimplex.com.au Technical Service: service@glendimplex.com.au www.glendimplex.com.au...

Table of Contents