Table of Contents
Advertisement
Pedestal Models:
Pecan Engineering Pty Ltd proudly supports the activities of Landcare Australia through its membership of the AHHA
FS 500 LE
FS 800 LE
Operating Instructions
Efficient—Warm—Friendly
Keep instructions in a safe place for future reference
Do not throw away
Insert Models:
IS 500 LE
IS 800 LE
Advertisement
Table of Contents
Related Manuals for Nectre Fireplaces FS 500 LE
Summary of Contents for Nectre Fireplaces FS 500 LE
-
Page 1: Operating Instructions
Pedestal Models: Insert Models: FS 500 LE IS 500 LE FS 800 LE IS 800 LE Operating Instructions Efficient—Warm—Friendly Keep instructions in a safe place for future reference Do not throw away Pecan Engineering Pty Ltd proudly supports the activities of Landcare Australia through its membership of the AHHA... -
Page 2: Air Controls
USER INSTRUCTIONS 1. INTRODUCTION AIR CONTROLS Before use of this appliance please read these instructions Cleanburn technology and greater efficiency fully. The Nectre Free-standing FS range and Insert IS range WARNING: ANY MODIFICATION OF THE APPLIANCE THAT feature a single air control system. It is designed to HAS NOT BEEN APPROVED IN WRITING BY THE TESTING introduce oxygen to into the base of the fire thereby AUTHORITY IS CONSIDERED AS BREACHING AS/NZS 4013. -
Page 3: Recommended Fuels
3. RECOMMENDED FUELS 5. RUNNING THE APPLIANCE Maximum Heat Output: Burn only seasoned hardwood timber with a moisture content of less than 20%. After establishing the fire and loading it with larger Newly cut wood should be allowed to dry/season for pieces of wood, leave it running with the air slide 12 to 18 months before use. -
Page 4: Ash Removal
Factors affecting the flue draught include: Reload with more wood: Insufficient flue height 1. Open air slide before opening door. Trees or other buildings nearby causing turbulence 2. Rake / break up any existing coals. High and gusty winds 3. -
Page 5: 11. Troubleshooting Tips
10. CLEANING THE FLUE 11. TROUBLESHOOTING TIPS 1. Glass in door blackening Check inside of flue prior to each season for any build up of creosote (wood tar). To do this:- This can have several possible causes: First remove the baffle (refer to “2. Replacement of Burning unseasoned wood —... -
Page 6: Maintenance And Servicing
Lift the baffle up at the back enough to clear the rear FS 500 LE & IS 500 LE – Brick Layout support pegs and slide forward so that the baffle can be lowered at the back. -
Page 7: Removing The Door
iii) Keeping the door in that position relative to the hinge, 3. REMOVING THE DOOR open it and tighten the screws until firm. Close the door to 90% again and make any final adjustments up or down by tapping the door on the To remove the door:- right hand side until it appears parallel relative to the Unscrew the air control slide rod. -
Page 8: Fitting A New Door Seal
b. Remove the T-shaped latch and remove one washer. Replace the latch and then place the remove washer over the rod. d. Refit the nut. Do not over tighten otherwise door handle will not turn easily. If door seal is still not tight enough remove another washer or replace door seal.