Onkyo TX-SR806 Supplementary Manual page 9

SETUP
Positioning the SiriusConnect Home
antenna
You can check the strength of the SIRIUS Satellite Radio
signal and adjust the position of the SiriusConnect Home
antenna accordingly.
1
Press the [RECEIVER] button,
followed by the [TUNER] button,
and [SETUP] button.
The main menu appears onscreen.
2
Use the Up and Down [q]/[w] but-
tons to select "7. Hardware
Setup", and then press [ENTER].
The Hardware Setup menu appears.
7. Hardware Setup
1. Remote Control
2. Zone2
3. Tuner
4. Analog Multich
5. HDMI
Note:
If the SAT Radio Mode is set to "None"
(see page 2), the "Antenna Aiming"
item is not available.
3
RECEIVER
4
5
Notes:
• So long as the signal strength is good, you can enjoy
SIRIUS Satellite Radio by using either satellite or ter-
restrial reception.
• Terrestrial signals are only available in certain areas.
• The SIRIUS information on the Satellite Radio screen
is only displayed when the SAT Radio Mode is set to
"SIRIUS" or "XM/SIRIUS" (see page 2).
• If you're using both XM Satellite Radio and SIRIUS
Satellite Radio and the Satellite mode is set to
"XM/SIRIUS" (see page 2), signal strength meters for
both systems appear on the same screen.
Use the Up and Down [q]/[w] but-
tons to select "3. Tuner", and
then press [ENTER].
The Tuner screen appears.
7–3. Tuner
SAT Radio Mode SIRIUS
Antenna Aiming
SURIUS Parental Lock
Use the Up and Down [q]/[w] but-
tons to select "Antenna Aiming",
and then press [ENTER].
The Satellite Radio screen appears.
The name of the currently selected
input selector is displayed in a box.
Position the SiriusConnect Home
antenna so that as many bars as
possible (up to 3) appear on the
SIRIUS Satellite signal strength
meter.
7–3. Tuner
SIRIUS Antenna Aiming
Satellite Terrestrial
- - - - - - - - - - - -
SIRIUS ID
If you cannot receive a satellite signal,
position the SiriusConnect Home
antenna so that as many bars as possible
(up to 3) appear on the SIRIUS Terres-
trial signal strength meter.
9
En-