Table of Contents
Advertisement
8. WELDING PARAMETERS RESTORE TO THE FACTORY SETTINGS
If you need to reset all welding parameters to the factory default values, you can do the
following operations:
In the non-welding state, press both buttons
together, and then
hold for 5 seconds until all the indicators on the panel are off, the display show
and panel has illuminated again. The factory setting of the welding parameters is restored!
9. OPERATING INSTRUCTIONS
Operation of the device should take place in an atmosphere free from corrosive ingredients
and high levels of dust. Do not place the device in dusty places, near grinders, etc. Dust and
contamination with metal filings of control boards, wires and connections inside the device
can lead to an electrical short circuit and consequent damage to the welder.
Avoid operation in environments with high humidity, in particular in situations of
condensation on metal elements.
In the case of condensation on metal elements, for example, after entering a cool device into
a warm room, wait until the condensation disappears. It is recommended that when the
machine is used outdoors, it should be placed under the roof in order to protect it from
adverse weather conditions.
10. MAINTENANCE INSTRUCTIONS
As part of everyday service, keep the welder clean, check the condition of external
connections and the condition of wires and electric cables.
Replace consumable parts regularly.
Periodically clean the device inside by blowing with compressed air to remove dust and
metallic filings from the control plates as well as wires and electrical connections.
At least once every six months a general review and condition of electrical connections
should be made, in particular:
- Protection against electric shock
- Insulation condition
- Security system status
- Correct operation of the cooling system
11. STORAGE AND TRANSPORT INSTRUCTIONS
The device should be stored at -10 ° C to + 40 ° C and relative humidity up to 80% free from
corrosive fumes and dust. The transportation of packaged devices should take place in
covered transport. During transport, the packed device should be secured against shifting.
20
Advertisement
Table of Contents
