Table of Contents
Advertisement
TX-LR552_En.book Page 9 Thursday, August 5, 2004 1:07 PM
Before Using the TX-LR552
Installing the Batteries
1
To open the battery compartment, press
the small hollow and slide off the cover.
2
Insert the two supplied batteries (AA/R6)
in accordance with the polarity diagram
inside the battery compartment.
3
Put the cover onto the remote controller
and slide it shut.
Notes:
• The batteries should last for about six months,
although this will vary with usage.
• If the remote controller doesn't work reliably, try
replacing the batteries.
• Don't mix new and old batteries or different types of
batteries.
• If you intend not to use the remote controller for a long
time, remove the batteries to prevent damage from
leakage or corrosion.
• Expired batteries should be removed as soon as pos-
sible to prevent damage from leakage or corrosion.
Using the Remote Controller
To use the remote controller, point it at the TX-LR552's
remote control sensor, as shown below.
STANDBY indicator
30˚
30˚
Notes:
• The remote controller may not work reliably if the
TX-LR552 is subjected to bright light, such as direct
sunlight or inverter-type fluorescent lights. Keep this
in mind when installing.
• If another remote controller of the same type is used in
the same room, or the TX-LR552 is installed close to
equipment that uses infrared rays, the remote con-
troller may not work reliably.
• Don't put anything, such as a book, on the remote con-
troller, because the buttons may be pressed inadvert-
ently, thereby draining the batteries.
• The remote controller may not work reliably if the
TX-LR552 is installed in a rack behind colored glass
doors. Keep this in mind when installing.
• The remote controller will not work if there's an
obstacle between it and the TX-LR552's remote con-
trol sensor.
Remote control sensor
9
Hide quick links:
Advertisement
Table of Contents
