Specifying The Digital Signal Format - Onkyo HT-S7100 Instruction Manual

Common Functions—Continued

Specifying the Digital Signal Format

The following table shows the display indicator for each
digital signal format.
Format
Dolby Digital
DTS
PCM
Normally, the AV receiver detects the format of digital
input signals automatically. However, if you experience
either of the following issues when playing PCM or DTS
sources, you can specify the signal format manually.
• If the beginnings of tracks from a PCM source are cut
off, try the PCM setting.
• If noise is produced when fast forwarding or rewind-
ing a DTS CD, try the DTS setting.
ON/STANDBY
STANDBY ZONE 2
PURE AUDIO
MULTI CH DVD VCR/DVR
PHONES
ZONE 2 OFF ZONE 2 LEVEL TONE
1
Press and hold the AV receiver's
[DIGITAL INPUT] button for about
DIGITAL INPUT
3 seconds.
2
While "Auto" is displayed (about
3 seconds), press the [DIGITAL
DIGITAL INPUT
INPUT] button repeatedly to
select: PCM, DTS, or Auto.
50
Display
PCM
TUNING PRESET
CBL/SAT GAME/TV AUX TAPE TUNER CD SETUP ENTER RETURN
SETUP MIC
MOVIE/TV MUSIC GAME DISPLAY DIGITAL INPUT RT/PTY/TP MEMORY TUNING MODE
CLEAR
DIGITAL INPUT
PCM: Only 2-channel PCM format
input signals will be heard. If
the input signal is not PCM,
the PCM indicator will flash
and there will be no sound.
DTS: Only DTS (but not DTS-HD)
format input signals will be
heard. If the input signal is not
DTS, the DTS indicator will
flash and there will be no
sound.
Auto (default): The format is
detected automatically. If no
digital input signal is present,
the corresponding analog input
is used instead.
MASTER VOLUME
AUX INPUT
VIDEO L AUDIO R
AV RECEIVER TX-SR606