Before Using; Checking Accessories; Preparing The Remote Controller - Onkyo DV-M301 Instruction Manual

Before Using

Checking Accessories

Please confirm that the following were received with the
changer.
Audio cord
Video cord
Master-Slave control cord
Remote controller
AA/R6P batteries
Remote control operation
30
5 m
(16 ft.)
8
30

Preparing the Remote Controller

Inserting batteries into the remote
controller
1
Push down on the tab on the battery
compartment cover, and pull out in the
direction indicated by the arrow.
2
Insert batteries.
Make sure to match the plus (+) and minus
(–) polarity guides on the batteries with the marks
inside the battery compartment.
3
Close the cover.
Notes
• Do not mix old and new batteries.
• When replacing batteries, use all new batteries.
• When not using the remote controller for a long period of time
(over 1 month), remove the batteries to avoid possible damage
from battery corrosion. If battery leakage occurs, wipe the
battery liquid from the battery component, then insert new
batteries.
When operating the remote controller, point it at the remote
sensor located on the changer's front panel. The remote
controller can be used up to 5 m (16 feet) from the changer
and within a 30 angle on each side of the sensor.
Notes
• Exposing the remote sensor to direct sunlight or strong light
may cause faulty operation.
• When Master-Slave connections are made to another DV-M301
to create a 601-disc changer, only the remote sensor on the first
DV-M301 will accept signals from the remote controller
(page 66).