Safety Precautions - Samsung AVXC1 Series Installation Manual

Safety Precautions

The following safety precautions must be taken when using your air conditioner.
WARNING
I
NSTALLING THE UNIT
The unit should not be installed by the user. Ask the dealer or authorized company to install the units.

If the unit is installed improperly, water leakage, electric shock or fire may result.

Mount with the lowest moving parts at least 2.5m above the floor or grade level. (If applicable)

The manufacturer does not assume responsibility for accidents or injury caused by an incorrectly installed

air conditioner. If you are unsure about installation, contact an installation specialist.
When installing the built-in type air conditioner, keep all electrical cables such as the power cable and the

connection cord in pipe, ducts, cable channels etc. to protect them against liquids, outside impacts and so on.
This appliance is not accessible to the general public. This appliance should be installed according to the

provided installation instruction.
When installing the air conditioner in a small room, the measure not to exceed the dangerous density is

needed.
- When refrigerant leaks and exceeds the dangerous density, suffocation may occur.
If any gas or impurities except R410A refrigerant come into the refrigerant pipe, serious problem may

occur and it may cause injury.
Use only rated accessories and install the air conditioner with rated equipments.

- If you dont't use the rated accessories, the air conditioner may drop from its place, water may leak or
electric shock or fire may occur.
Ventilate your room when refrigerant gas leaks during installation.

- Toxic gas may generate when refrigerant gas contacts with heat.
P
OWER SUPPLY LINE OR CIRCUIT BREAKER
If the power cable of this air conditioner is damaged, it must be replaced by service agent or similarly

qualified persons in order to avoid a hazard.
The unit must be plugged into an independent circuit if applicable or connect the power cable to the

auxiliary circuit breaker. An all pole disconnection from the power supply must be incorporated in
the fixed wiring with a contact opening of >3mm.
The air conditioner must be installed in accordance with national wiring regulations and safety

regulations wherever applicable.
The electric work must be done by service agent or similarly qualified persons according to national

wiring regulations and use only rated cable.
- If the capacity of the power cable is insufficient or electric work is not properly completed,
electric shock or fire may occur.
Install the cables with supplied cables firmly. Fix them securely so that external force is not exerted to the

terminal board.
- If the connection or fixing is incomplete, heat generation, electric shock or fire may occur.
Connect the power cable between the indoor and outdoor unit properly so that the electrical

component box cover is not get loosen and attach the cover securely.
- If the the cover is attached incompletely, heat generation, electric shock or fire of the terminal
board may occur.
• Risk of electric shock can cause injury or death.
• Disconnect all remote electric power supplies before servicing,
installing or cleaning.
• Installation must be done by the manufacturer or service agent or a
similar qualified person in order to avoid a hazard.
3
E-