Logitech MKZ260 Wireless Combo with Speakers Manual

Features

1. Play/pause
2. Mute volume
3. Decrease volume
4. Increase volume
5. Navigate to Internet home
6. Launch email application
7. Place PC in standby mode
8. Launch calculator

Help with setup

• Check the battery installation in the keyboard and mouse, or replace the batteries.
• Plug the receiver into a different USB port. Remove any metal object between the receiver and the keyboard/mouse that may interfere with reception.
  
• Try moving the keyboard/mouse closer to the receiver.
• If the receiver is plugged into a USB hub, try plugging it directly into your computer.
  
• Restart the computer.
• If these suggestions don't work, download the Reconnection Utility from http://www.logitech.com/connect_utility.

Replacing keyboard batteries

1. Open battery compartment on keyboard bottom.
2. Remove old batteries.
3. Wait 15 seconds before inserting the new batteries to allow the keyboard to reset.
4. Follow diagram in battery compartment to insert two new AAA batteries in keyboard. Close battery compartment.

Replacing mouse battery

1. Press on battery compartment door and slide down to open.
2. Remove old battery.
3. Follow diagram in battery compartment to insert one new AA battery. Close battery compartment.

Safety

1. Unplug the speakers from the computer before cleaning them with a dry cloth.
2. For added protection during lightning storms, unplug the speakers from the USB port and turn off the computer.
3. Servicing is required when the apparatus has been damaged in any way, such as when the power cord or plug has been damaged, liquid has been spilled on the apparatus or objects have fallen into it, or the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.

Setting up your Digital USB speakers

1. Connect the USB cable on the right speaker to an available USB port on your computer.
2. Adjust the volume on your speakers. Volume Up, Volume Down, and Mute will work with any audio software application. Mute will silence the speakers. To release Mute, press the Mute button again.

Volume controls

1. Volume up
2. Mute
3. Volume down
4. LED indicator

Troubleshooting

Speakers produce weak or no sound

Is the power light on? Make sure the speakers are plugged into your computer's USB port and the power light is on. Has the computer recognized your speakers? Open your computer's sound mixer program. In Windows® you'll find this program opening "Sounds and Audio Devices" in your Control Panel. Make sure that "USB Audio Device" is selected in the hardware settings. You may also unplug the USB cable and plug it in again. Are the speakers muted? To release Mute, press Mute again.

Specifications

Total RMS Power: 1 Watt (0.5W + 0.5W) into 4 ohms at 1 kHz at 10% THD (total harmonic distortion).
System THD: Better than 10% THD before clipping.
Signal to noise ratio: >100dB.
Frequency response: 20Hz~20kHz.
Driver Size: 2" (5 cm) driver.

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Logitech MKZ260 Wireless Combo with Speakers Manual