Advertisement
Quick Links
No LED on remote?
Replace batteries with (4) new AAA alkaline batteries. We do not recommend the use of 'rechargeable' batteries in
the remotes.
LED blinks when I hit a key, but not twice when I try to program the remote?
TAP the DEVICE (TV, VCR, CABLE, etc.) button and release
HOLD DOWN the SETUP button until TWO blinks - release
ENTER 9-9-2 (two blinks)
TAP the DEVICE (TV, VCR, CABLE, etc.) button TWO times (two blinks)
Now try reprogramming the setup code for your device.
Volume not working on cable box or VCR?
Some cable boxes and VCR's do not have volume functions at all. Be sure that you have your TV programmed to the
remote, and use the VOLUME PUNCH THRU instructions in your manual or on the website to duplicate the volume
functions on the cable box or VCR.
Volume not working on a CD, cassette, LD, or DVD player?
Many of these devices do not have their own volume control, but depend on an amplifier or receiver for volume.
Use the 'KEY MOVER' instructions in your manual or on the website to transfer the volume control.
Not able to directly access channels using numbers (0-9)?
Some cable converters and TV's require the user to hit an ENTER button after the number button to "lock in" the
channel. Universal remote requires the same sequence.
CH +/- and PREV CH not working on your RCA TV?
If there are no CH +/- buttons on the front of the TV set, due to RCA design (1983-1987), only the original remote will
perform these functions.
Not able to access al the available channels on my TV or VCR?
Many TV's or VCR's require you to 'auto program' the channels if there has been a power failure or other interruption
of service. Also, if you are receiving CABLE with out the use of a cable converter, you may have to switch the TV or
VCR to CATV mode in order to pick up the signal correctly. The instructions for these are in the manual for your TV or
VCR. After finding the correct procedure for your particular device, use the corresponding keys on the remote to
duplicate the procedure from your TV or VCR manual.
No picture on TV when using a cable converter?
Be sure the TV is on the correct channel (usually 3 or 4) so it can receive a signal from the cable converter .
Remember to ONLY change channels on the cable box or you will lose the signal.
FAQ QUESTIONS AND ANSWERS
URC9900
Advertisement
Related Manuals for One for All URC-9900
Summary of Contents for One for All URC-9900
- Page 1 FAQ QUESTIONS AND ANSWERS URC9900 No LED on remote? Replace batteries with (4) new AAA alkaline batteries. We do not recommend the use of 'rechargeable' batteries in the remotes. LED blinks when I hit a key, but not twice when I try to program the remote? TAP the DEVICE (TV, VCR, CABLE, etc.) button and release HOLD DOWN the SETUP button until TWO blinks - release ENTER 9-9-2 (two blinks)
- Page 2 page 2 Distance from remote to equipment? For the best results, remote must be within 12ft. of your equipment before using the remote. *** URC-9800 IR/RF remote - for best results, "Command Center" box should be within 12 ft. of equipment, at table height.
- Page 3 'universal' RF remotes. The URC-5061 'One For All 5' remote with the 'Finder' is constantly beeping without using the transmitter? Your remote is receiving radio frequency signals, possibly from outside your home, that it is interpreting as prompts to activate the 'Finder'.