HP 9000 300 Series Service Handbook page 83

2. From the Auto System Select Mode note the tape drive with the System
Support Tape with these operating systems:
SYSTEILSF
SYSTEILS3
3. Select SYSTEM_SF as the temporary operating system to boot if you want
to run the Series 300 System Functional Tests.
4. Select SYSTEM_S3 as the temporary operating system to boot if you want
to run the Series 300 Controller Tests.
5. Refer to the System Support Tape User's Guide and the Series 300 Test
Tools Manual for detailed instructions.
6. To continue and run specific CE.utilities tests, boot the HP-UX operating
system. The remaining steps of this procedure can only be performed with
the HP-UX operating system running.
7. To list all tests on the tape, type this command where drive is the device
file name of the tape drive:
lifls /dev/drhe (Enter )/(Retw:n)
8. To find out what files are a>'ll.ilable for a certain test, type this command:
lifcp -r /dev/drive: filename! - I cpio -ictv (Enter)/(Retw:n)
where filenamel is one of these four CE.utility tests:
CltTlDJ
Note
FLOAT
SFT
ECC
CS/80, VME, HP 98720A and HP98730A tests are not
supported on Model 362/382 controllers. Also, the ECC test
only applies to the Model 382, as the Model 362 does not have
ECC memory.
9. If you want to list the file names for a specific ce.utility test in a new file,
type this command where filename2 is the name of the file you want to list
the files in:
lifcp -r /dev/drive: filename! - I cpio -ictv filename2 (Enter)/(Retum)
Diagnostics 5-13