HP 9000 300 Series Service Handbook page 41

Use the specified keys to change the features listed. To change the Select Code,
press
G),
or the change the bus address, press
G).
When you select a value to
change, the prompt line changes. For example, to change the SCSI's Select
Code, do the following:
Press
G)
(Return )/(ENTER)
Then the command line changes to:
1
Select Code
used select codes are
12
14
15 21
14
Type 0 .. 31 except used RETURN?
• The select code function line shows the current information.
• Select codes already used and not available and are listed in the third line.
• The prompt line is next.
To change the SCSI select code to 23, enter 23 (Enter )/(Return). The display
would not look like the following:
1
Select Code
used select codes are
12 15 21 23
23
Type 0 .. 31 except used RETURN?
Other interfaces and features would be selected and changed the same way.
After you hav" made interface configuration changes your controller needs, exit
the interface menu by entering® (Enter )/(Return). The Configurable Interfaces
Menu will re-appear.
Select any other interface and configure it according to your application needs.
After configuring your controller's internal interfaces as required store the new
interface values in memory by entering@ (Enter )/(Return).
The system will re-boot with the new values.
Configurations 3·9