6. Pull the circuit board out two inches more. Locate the connector
marked CN3 on the front right corner of the circuit board (see Figure
A-8 above) and carefully unplug it.
7.
Remove the main circuit board completely from the computer.
Figure A-9 shows the locations of jumpers 2 and 3. Refer to Table A-2
above to set them as needed.
CN6
When you finish changing the jumpers, follow these steps to reinstall the
main circuit board:
1.
Slide the board back into the computer, guiding it along the black tracks
on either side of the opening, until it sticks out two inches.
2.
Reconnect the connector marked CN3 on the front right corner of the
main circuit board.
A-8
Figure A-9. Main circuit board jumpers
CN3