Option Card Problems - Epson Equity III User Manual

Option Card Problems

If you install an option card and get unexpected results, check the
following:
1.
Is the option card installed correctly?
2. Did you follow the setup and operation procedures in the option card
instructions?
3. Did you set any necessary DIP switches or jumpers on the option card?
See your option card instructions.
Did you change any necessary jumper settings in the main unit? See
4.
Appendix A, "Jumper Settings."
5. If you added an external device, did you use the proper cable to connect
the peripheral to the port or option card connector on the back panel?
6. Did you perform any necessary post-installation setup procedures for the
operating system? See your Diagnostics, MS-DOS, or other software
manual for instructions.
5-5