5.
Once the connector pins are sitting in the connector slot, push the card
downward firmly (but carefully) to fully insert it. If the card does not go
in smoothly, do not force it-pull it all the way out and try again, keep-
ing it straight.
6.
Secure the adapter plate on the end of the card to the back of the com-
puter with the retaining screw.
Removing an Option Card
To remove an option card, follow the same basic procedure you used to
install it. Remove the screw holding the adapter and pull the card straight up
and out of the connector. Then carefully wrap the card, preferably with the
original packing materials, and place it inside its box for safe storage. Cover
the end of the empty option slot with the original metal cover and retaining
screw. If you modified anything in the post-installation setup (see below) be
sure to change it back.
4-6
Figure 4-7. Inserting an option card