Table of Contents
Advertisement
①
Global = For Local and Remote in function
②
If you use these inputs, remove the jumper.
③
As long as P-INTERFACE:Reset source is set to Global, all reset sources are always effective.
④
Max. current load of the control voltages:
•
+24 V DC, potential 2: 300 mA
•
+15 V DC, potential 2: 150 mA ±10 mA
This voltage can supply a speed encoder connected at terminal -X101.
⑤
Remove both these jumpers if you are using peripheral boards 3 / 4. The supply is realized via -X2:1/3.
Figure 8-29
Control cable terminals for the "Standard" application
8.8.1.2
Control cable terminals "peripheral board 1"
Figure 8-30
8.8.1.3
Control cable terminals "peripheral board 2"
①
③
Figure 8-31
Installation and Operating Instructions for LOHER DYNAVERT I Series 7
Operating Instructions, 10/2022, 4BS0745-002
Control cable terminals for the "peripheral board 1" option
PTC inputs, suitable for motors in hazardous zones or non-hazardous zones
Remove the 100 Ω resistor if these control cable terminals are in use.
Control cable terminals for the "peripheral board 2" option
Operation
8.8 Examples / Applications
117
Advertisement
Table of Contents
