Epson ActionTower 7500 User Manual page 107

Connecting the hard disk drive cubles
After you replace the bracket, you need to connect the cables to
hard disk drive. Follow these steps:
the
1. Locate one of the IDE device cables that are connected to
the IDE interfaces on the system board. They are flat cables
with a system board connector on one end and two IDE
device
one side of the cable. (See "Locating System Board
Components" in Chapter 4 to find the primary and
secondary IDE interfaces on the system board.)
Use the primary IDE interface for your boot drive and your
second hard disk drive; use the secondary IDE interface to
connect
third and fourth drives. You cannot
drive and hard disk drive to the same interface.
connectors on the other end. A red wire runs down
IDE CD-ROM drives, other IDE devices, or your
Installing and Removing Slimline Drives
connect a CAROM
5-9