Table of Contents
Advertisement
4. Position the IDE device cable so the side with the red wire
aligns with pin 1 on the drive. Make sure the holes in the
connector fit over all the pins; then push in the connector.
5.
Locate one of the power supply cables that lead from the
power supply. (They have multi-colored wires and a plastic
connector on the end.) Align the notched comers of the
power supply connector and the drive's power connector;
then push in the connector, as shown above.
Note
Your system has five power supply cables; three with
large connectors and two with small connectors. If you
need more than five cables, you can purchase Y-adapters
at most computer accessory stores. Y-adapters let you
use one power supply cable for two devices.
6. If you have finished installing or removing drives, replace
the computer's cover; see "Replacing the Cover" in Chapter
4
for instructions. Then see "Running SETUP" in Chapter 2
for instructions on defining your new drive configuration.
Installing and Removing Drives in
Tower Computer
the
6-7
Advertisement
Table of Contents
