Genelec 4435A Operating Manual

Genelec 4435A Operating Manual

Smart ip in-ceiling installation speaker

Advertisement

Quick Links

4435A
Operating Manual
Genelec 4435A
Smart IP In-Ceiling Installation Speaker

Advertisement

Table of Contents
loading

Summary of Contents for Genelec 4435A

  • Page 1 4435A Operating Manual Genelec 4435A Smart IP In-Ceiling Installation Speaker...
  • Page 2: Installation

    If you are installing the 4435A to an existing When you have found a good location, construction, examine the ceiling thoroughly...
  • Page 3 RESET BUTTON HOLE CABLE STRAIN RELIEFS Figure 1. Front and rear views of the 4435A Figure 3. Screws for tightening the mounting latches are located at the Figure 2. Connector panel of the 4435A edge of the front baffle through which you can probe the inside of...
  • Page 4 Each PoE supply device (IP switch or ports power injector) has a certain maximum output power capacity. This can limit the Figure 5. 4435A powered by an IP PoE+ power injector number of PoE outputs that can be set on.
  • Page 5: Network Structure

    100 meters (333 feet). Calculate the power loss in cable at 25 mW/m or 7.4 Figure 6. 4435A power supply enables high output level peaks exceeding the incoming mW/ft. The 4435A will automatically adapt to PoE power level; the PoE standard limits the duration of the peaks...
  • Page 6: Analogue Input

    An AES67 audio stream supported by the loudspeaker can have the maximum of 8 audio channels. The 4435A can select one audio channel or a sum of two channels in a stream. In demanding installations, where...
  • Page 7: Maintenance

    The power consumption in the ISS that it does not reactivate. state for 4435A is 4 W. To save more power, Driver thermal overload protection recommended the PoE+ power supply in the Ethernet protects the drivers from damage caused by •...
  • Page 8 Maximum short-term output level is limited by the PoE technology being used and the crest factor of the audio signal. The stated values are typical for music and speech signals. Maximum long-term output level can be further limited by loudspeaker system protection. Genelec recommends using PoE+ whenever possible. Using lower-power PoE can limit short-term maximum and long-term maximum, depending on the characteristics of the signal being reproduced.
  • Page 9 Maximum CAT cable length 100 m (333 ft) Power consumption in idle Power consumption in ISS power-down mode 4435A (2023−01−05) Frequency (Hz) Figure 9. On-axis frequency response at 1 m. The shown frequency response is typical in a recessed ceiling...
  • Page 10 Square grille thickness 4 mm (1/8 in) 288 mm (11 3/8 in) Round grille thickness 10 mm (3/8 in) Figure 10. Dimensions of the 4435A with a round grille attached measured from the middle (the grille is slightly convex) and the dimensions of the grilles.
  • Page 12 Genelec 4435A Smart IP In-Ceiling Installation Speaker www.genelec.com Genelec Document D0187R001. Copyright Genelec Oy 2.2023. All data subject to change without prior notice International enquiries: In the U.S. please contact: In China please contact: In Japan, please contact: In Sweden please contact Genelec, Olvitie 5 Genelec, Inc., 7 Tech Circle...

Table of Contents