Communication Setup Options - Epson PowerLite 8300NL User Manual

24 frames per second (fps) and convert it to 60 fps for a more
natural appearance; or select
Selecting projects interlaced signals without converting them
OFF
to progressive, which improves the look of images that contain a
lot of movement.
BNC Sync Termination (in the Advanced2 menu)
This setting should normally be left
analog (75-ohm) terminator is required, as for a switcher, change
the setting to .
ON

Communication Setup Options

These options let you set up the projector so it can be monitored and
controlled from a remote computer (see Chapter 5).
Standby Mode (in the Advanced1 menu)
Select
Network ON
controlled over a network, as described in Chapter 5, when it's in
standby mode (plugged in but not turned on).
This setting also lets you view images on an external monitor
during standby, if the monitor has been connected to the
projector's Monitor Out port (see page 28). The projector does
not go into full sleep mode (see page 43) when this setting is in
effect.
Network (in the Advanced2 menu)
Used for managing the projector over a network (see Chapter 5).
If the network assigns addresses automatically, turn on
Otherwise, turn off
, and
Subnet Mask
If you want to monitor the projector using a network
management utility, select
address.
COM Port (in the Advanced2 menu)
Used for communicating with a computer running EMP Link21L
utility software. Select
to prevent frame conversion.
Video
(for TTL input). If an
OFF
to enable the projector to be monitored and
and enter the projector's
DHCP
, if applicable.
Gateway Address
and enter at least one trap IP
SNMP
or , depending on the port
RS-232C USB
note
When this setting is on, you
cannot view or change the
projector's network settings.
note
.
DHCP
Press the
, the remote control to use the
IP Address
number keypad.
Num button
Fine-tuning the Projector
button on
Num
Zero
0
71