Jenn-Air JES9750 User Manual page 6

S
C
URFACE
C C
OOKTOP ARTRIDGE
Cooktop cartridges, either conventional
coil, halogen or radiant element, can be
installed on either side of the range. (See
page 21 for all available cartridges and
accessories, and their model numbers.)
TO INSTALL CARTRIDGES:
1. If the grill grates, element, and/or basin
pan are in place, remove before install-
ing a cooktop cartridge. Clean porce-
lain basin of any grease accumulation.
(See page 19 for cleaning recommenda-
tions.)
2. To install any of the optional cooktop
cartridges, be sure controls are turned
Off and the cartridge is cool. Position
the cartridge terminal plug towards the
terminal receptacle. This receptacle is
located at the front of the left side and
at the back of the right side of the range.
3. Slide the cartridge towards the recep-
tacle until the cartridge terminal plug is
completely engaged.
4. Lower the opposite end of the cartridge
into the rangetop until it is flush with the
surface. Your range is now ready to use.
TO REMOVE CARTRIDGES:
1. Controls must be Off and the cartridge
should be cool.
2. Lift up the edge of the cartridge until top
of cartridge clears the opening on the
range by about 2 inches. (Lifting the
cartridge too high while still engaged in
the receptacle could damage the termi-
nal plug.)
,
OOKING
CONT
I
NSTALLATION
3. To disengage terminal, hold cartridge by
the sides and pull away from the termi-
nal receptacle. Lift out when fully un-
plugged.
4. Do not stack cartridges where they may
fall or be damaged. Never store other
materials on top of the glass-ceramic
cartridges since this could damage or
scratch the surface.
H
OME
Canning should be done on the conven-
tional coil cartridge only. Canning element
accessory, Model A145A, makes it possible
to use large oversized canners with the
conventional coil cartridge.
For additional information, refer to use and
care manual packaged with your cartridge.
G
RILL
The grill accessory consists of two black grill
grates, a grill element and a basin pan. It may
be installed on the left side of the cooktop
only.
TO INSTALL GRILL:
1. Before installing grill components, be
certain controls are Off.
2. Place the basin pan into the empty basin.
.
C
ANNING
I
NSTALLATION
5
3. Position the grill element with the ter-
minal plug towards the terminal recep-
tacle. This receptacle is located at the
front of the left side of the range. Slide
the element towards the receptacle
until the terminal plug is completely
engaged and supports rest on the sides
of the basin.
4. Place the grill grates on the top of the
cooktop.
TO REMOVE GRILL:
1. Be sure controls are Off. Remove grill
components when they are cool.
2. To remove grill element, pull away from
receptacle until it is unplugged. (NOTE:
Lifting the element more than 2 inches
above the cooktop surface while it is
engaged in the receptacle could damage
the terminal plug.)