Exit Selectype And Reset The Printer - Epson ActionLaser User Manual

7. Press the
SET
blinking, and the option starts blinking.
8. Use or
the
9. Press the
SET
indicating that the new option has been set. The option stops
blinking and
10. To exit the emulation submenu and return to the main menu,
use or
the
message
I/F
If you wish to exit SelecType at this point, see the section below on
exiting SelecType.

Exit SelecType and reset the printer

To exit SelecType (from any main menu or submenu function) and
implement your changes, follow these steps:
1. When you have set all the options you want, press the SelecType
button. The printer is set off line.
2. Hold down the
message
the
options are implemented in the printer's
change them or initialize them to the factory settings.
Note: To implement changes to
and interface submenu settings you must also turn the
LOAD,
printer off. Remember to leave the printer off for at least five
seconds before turning it back on.
button to activate
button to move to the option you want to set.
button. An asterisk (*) appears next to the option,
function starts blinking.
the
button to take you back to
= SERIAL* appears in the display.
CONTINUE/RESET
appears) to implement your changes. The
RESET
option. The function stops
the
main menu. The
the
button for three seconds (until
memory
the DATA BUFFER, OVER
Using the Printer
Using SelecType
until you
3-17