INDEX PAGE
REMOVAL & REPLACEMENT
Listed below are some of the considerations that you should keep in mind during the
disassembly and assembly of the computer:
To service the computer, you need the following:
Torx T-8 screwdriver (with option for flathead on most screws)
7mm (1/4 in.) socket nut driver (for removal of Docking connector to remove system
board)
The screws used in the computer are not interchangeable. If an incorrect screw is used during
the reassembly process, it can damage the unit. Compaq strongly recommends that all screws
removed during disassembly be kept with the part that was removed, then returned to their
proper locations.
Using excessive force during disassembly and reassembly can damage plastic parts. Use care
when handling the plastic parts. Apply pressure only at the points designated in these
maintenance instructions.
As each subassembly is removed from the computer, it should be placed away
IMPORTANT:
from the work area to prevent damage.
MAINTENANCE & SERVICE GUIDE
P
ROSIGNIA
PRODUCT DESCRIPTION
ILLUSTRATED PARTS CATALOG
Removal & Replacement
Service Considerations
Tool Requirements
Continue Preliminary pages:
Cables & Connectors
Preparing Computer for Disassembly
N
190
OTEBOOK
LEGAL NOTICE
TROUBLESHOOTING
Screws
Plastic Parts
HOW TO USE THIS GUIDE
SPECIFICATIONS