Table of Contents
Advertisement
To connect the battery to the product
WARNING:
original batteries with the product.
1. Make sure that the battery is fully charged.
2. Push the battery into the battery holder of the
product. The battery locks into position when you
hear a click.
CAUTION:
move easily into the battery holder, the
battery is not installed correctly. This can
cause damage to the product.
3. Make sure that the battery is installed correctly.
Work position
•
Hold the product with 2 hands.
•
Hold the product on the right side of your body.
•
Keep the cutting attachment below waist level.
•
Keep body parts away from the hot surfaces.
•
Keep body parts away from the cutting attachment.
Before you operate the product
•
Examine the work area to make sure that you know
the type of terrain. Examine the slope of the ground
and if there are obstacles such as stones, branches
and ditches.
•
Do a general inspection of the product.
•
Do the safety inspections, maintenance and
servicing that are given in this manual.
•
Examine the motor for dirt or cracks. Use a brush to
clean the motor from grass and leaves. Use gloves
when it is necessary.
•
Examine the trimmer head and cutting attachment
guard for damages or cracks. Replace the trimmer
head and cutting attachment guard if they are hit or if
they have cracks.
•
Make sure that all nuts and screws are tight.
•
Make sure that all covers, guards, handles and the
cutting equipment are correctly attached and not
damaged before you start the product.
1937 - 002 - 06.12.2022
Only use Husqvarna
If the battery does not
To start the product
Note:
The product identifies the cutting attachment
when the cutting attachment is changed and the power
trigger is pressed. The product stops and the LED
flashes until the power trigger is released and moves
back to its initial position. The cutting attachment is at
this time identified and prepared for operation.
1. Push and hold the start button until the green battery
LED and the white mode LED comes on.
2. Use the power trigger to control the speed.
To limit the maximum speed with the
mode button
Note:
The maximum speed is related to the cutting
equipment that is attached and identified by the product.
When a blade is attached, the maximum speed is
higher than when a trimmer head is attached. Refer to
Technical data on page 18 .
The product has a mode button. With the mode button
the operator can limit the maximum speed. The mode
button has 3 speed levels. A lower level increases the
time of operation for the product. Use level 1 and level
2 if the operation does not require full speed/full power.
If the operation condition requires full speed/full power,
use level 3.Do not use a higher level than necessary for
the operation.
1. Push the mode button to set a limit to the maximum
speed. The white LEDs comes on to show that the
function is on.
2. Press the Mode button again to choose the next
speed level.
13
Advertisement
Table of Contents
