Nikon D-LEDI Instructions Manual page 41

Remote control pad
Status display
Switching to a standby
state
Operating the menu
On/off and brightness
control
Illumination control
Operation
Connection
Power
Applicable fluorescence filter cubes
Model name
Main specifications
Chapter 6 Specifications
2.7-Inch organic EL display (128 × 64 pixels)
The display can be turned on and off by using the slide switch on the left side.
Provides a beep sound (can be enabled or disabled)
The illuminator can be turned on and off by using the push switch on the right side.
Pressing the MENU button displays the operation menu on the screen.
Turn the illumination control dial to select an item, and then press the illumination
control dial to apply.
Major functions can be assigned to the Fn button.
Switches between the simultaneous illumination control mode and individual
illumination control mode (operation via the display)
Simultaneous illumination control mode:
Individual illumination control mode:
Adjustment is made by rotating the push switch with a rotary encoder.
Illumination control mode: Can be switched between the simultaneous and
Illumination control step:
• Excitation light emission synchronized to the image capture timing on the CCD
camera (time-lapse observation)
• Supports the trigger acquisition function
Switches:
Display part:
Cable:
Connection destination:
Communication standards: Special-purpose
Operating power:
Power supply:
C-LED385 Fluorescence filter cube
C-LED470 Fluorescence filter cube
C-LED525 Fluorescence filter cube
C-LED625 Fluorescence filter cube
Dedicated for D-LEDI; supports each wavelength of the LED illumination system.
Refer to "1.3 Recommended Fluorescence Filter Cubes."
31
Pressing the illumination control dial turns all the LEDs
on and off.
Pressing the SELECT button selects a target LED.
Pressing the illumination control dial switches the LED
on and off.
individual illumination control modes.
0 to 100 (101 steps for each LED)
In simultaneous illumination control mode, brightness
can be controlled while maintaining relative brightness
between wavelengths.
1 slide switch (left side)
4 push buttons (3 on the top, 1 on the right)
1 push switch with a rotary encoder
1 OLED display
Connected with a cable directly from the remote control
pad
D-LEDI main body REMOTE connector (14 pin)
+12 VDC
Provided via a remote control connection cable from
the D-LEDI main body.