Chapter 2 How To Use The Parts; Controlling The Power; Turning The Main Power On Or Off; Turning The D-Ledi Main Body On Or Off - Nikon D-LEDI Instructions Manual

Fluorescence led illumination system

Hide thumbs

Table Of Contents

Table of Contents

Chapter 2

How to Use the Parts

2.1

Controlling the Power

The main power switch on the back side of the D-LEDI main body and the standby button on the right side of

the remote control pad are used to control the power of this product.

2.1.1

Turning the Main Power On or Off

Use the main power switch on the back of the D-LEDI main body to control the main power of this product.



Turning the main power on or off

Main power switch

Set to the "I" side.

Set to the "O" side.

In normal operation, keep the main power switch on,

and use the standby button on the remote control pad

to turn the D-LEDI on or off.

Turning the main power off during assembling or connection

When attaching or connecting this product, set the main power switch to the "O" side to turn off the main power.

Standby state

Standby refers to a state in which only the main power is on, while the D-LEDI main body is turned off.

To turn off this product in normal operation, press and hold the standby button on the remote control pad to put

this product in a standby state.

2.1.2

Turning the D-LEDI Main Body On or Off

To turn the D-LEDI on or off, check that the main power switch is on, and then press the standby button on the

remote control pad.



Turning the D-LEDI main body on or off

Standby button

Momentarily press

Press and hold

When the D-LEDI main body is turned on, the display of the remote control pad lights up.

Saving the settings in the standby state

If you use the standby button to turn off the product, the brightness and other settings at that time are saved

automatically. If you use the standby button to turn on the product, the settings are restored.

Turning the display on or off

The display of the remote control pad can be turned off by using the DISP switch on the left side.

You can also configure in the MENU screen to automatically turn off the display after the operation (see 2.4.3).