Epson SureColor S30670 Quick Reference Manual page 10

Lower the media loading lever to hold the media in place.
11.
Note: Media that is left in the feed path with the heater activated may buckle. If this happens, raise and
lower the media loading lever to allow the media to flatten.
When you are ready to print, attach the media holding plates at either side of the media.
12.
First, position the plates so that the edges of the media are in the centers of the round holes. Adjust the
position so that the white line is visible in the square window, then push the plates down to lock them
in place.
Caution: To avoid damaging the print head, do not use the media holding plates with media that is more than
0.02 inch (0.4 mm) thick. To avoid printing over the plates, make sure the side margins of your print are at
least 0.39 inch (10 mm). Remove the media holding plates when they are not in use.
Close the front cover.
13.
Loading Media |
9