Install Software; Load Paper In The Cassette - Epson WorkForce Pro WP-4090 Quick Setup Instructions

4
Load paper in the cassette
You can load letter-, A4-, or legal-size plain paper in the
cassette. For instructions on loading envelopes and special
paper in the rear MP tray, see the online User's Guide.
1
P ull out the paper cassette.
2
S lide the edge guides outward, and position them for the
size of paper you are using.
N ote: If you are loading legal-size paper, extend the cassette as
shown.
3
I nsert the paper with the glossy or printable side face
down.
N ote: Make sure the paper is loaded against the front edge
guide and not sticking out from the end of the cassette.
4
S lide the edge guides against the paper, but not too
tight. Make sure the paper is under the tabs on the edge
guides.
5
G ently insert the paper cassette.
N ote: The paper may slide forward slightly as you insert the
cassette. This is normal.
6
E xtend the output tray and raise the paper stopper as
shown. (Do not raise the stopper for legal-size paper.)
5
Install software
If you're using the product as a laser printer replacement,
you do not need to install any Epson drivers.
Note: To use the Fax Utility and Epson Status Monitor, install the
standard Epson driver. If you want to install multiple drivers, repeat
the software installation process as necessary. For more information,
see your online User's Guide.
If you want to install Epson drivers, follow the steps below.
Note: If a computer does not have a CD/DVD drive, you can
download the software from the Epson website (see "Epson technical
support").
Caution: Be sure to close any other programs, including any screen
savers and virus protection software, before beginning this software
installation.
1
M ake sure the printer is NOT CONNECTED to a
computer.
W indows : If you see a Found New Hardware screen, click
®
Cancel and disconnect the USB cable. You can't install your
software that way.